The Argolis Wireless One is the only thing you need for your IoT solution. The stand alone Arduino compatible printed circuit board is full with features. If you use e.g. Windows7 64-bit on your PC, smartreader.

With EMBEST ide for ARM tool, with this jtag interface, you cand read write this AT91SAM7S64 ic witch is the main ic on Smargo circuit board. GND PLEASE IF YOU ABLE TO BUILD THIS JTAG INTERFACE AND MAKE A DUMP, SEND IY FOR US. Are u 100% sure you can read the ARM? Its not write protected? Im up for the challenge.

Ill try do a upload so other austech members can use it. Only if GW1 was here.

Hi all If somebody has smargo 'demaged' by update but the geen LED is lighting after plugging to the USB is probably chance to back it to live Make simple test: 1. Insert smargo to USB - green LED should light but system doesn't recognise device. Insert some smart card revrserd to the slot to active card detect only - green led should start blink. 3 inster card properly - green led should be dark If all points pass it means u have some chance to repair smargo. To repair it u must open the case to have access to the electronic board.

Put the board USB plug up. Free blackberry 8520 software download. At right side u should have small 3 pin transistor and more at rite side 3 holes placed vertically.

We are interested in this small transitor. It has 3 legs/pins up and 1 down. We are interested in it's right up leg/pin (base or gate). Solder small wire to this leg/pin and connect second side to GND.

I've connected it small capacitor located below r-pack (right side of the capacitor) but u can connect it anywhere u find GND After that u can connect smargo to the PC and it should be normally detectable. Run./srp_update_x86 -b to activate bootloader mode. Remove and reinsert smargo. Run./srp_update_x86 -f to flash reader again.

If u see this message: start flashing ################################################## ######## done Please remove and reinsert SmartReader+ wait about 2-3 minutes and then disconnect your smargo reader. After this process u can remove the wire and smargo should be alive again Probably not all smargo will get up after this process but is probably the most of them get a cure.